3 pillow care, Pillow care – Sundance Spas CONSTANCE 6530-512X User Manual

Page 42

Page 38

ELITE SERIES

draining Procedures:

1. Turn off power to spa at breaker.

2. Locate the 3" gray drain valve cap on side of the

spa cabinet. Unscrew drain valve cap to expose the

underlying male garden hose fitting (Fig. G-I).

3. Attach female garden hose end to drain fitting and

route opposite end of garden hose away from spa

(Fig. H).

4. Pull outward on garden hose end at drain

connection (approx. 3/8") to open drain valve and

release water from spa (Fig. I). Water drains at

approximately 3 gallons per minute.

5. After spa has drained, close drain valve by pushing

inward on garden hose end at drain connection until

you feel it bottom out. Remove garden hose and

install gray drain cap before refilling spa.

Note: The gray drain cap cannot be installed until the

drain valve is closed. Refer to “Spa Fill Up Procedure”

(page 15) for recommended filling instructions.

11.3 Pillow Care

Remove and clean the headrest pillows as needed

with soapy water using a cloth or soft-bristle brush.

Always remove the pillows when adding chemical shock

treatment to the spa water. The pillows can be returned to

the spa when the sanitizer reading drops below 4.0 ppm.

Pillow Removal/Cleaning Procedure

Figure G

Figure H

Figure I

3/8"

Place both hands on

pillow with thumbs as

shown.

Press inward with

thumbs to curl pillow

lip inward so you can

grab it with fingertips.

Flex pillow lip inward

2-3" to get a good

grip on the ends.

Gently pull outward on

pillow to release mounting

stud from receptacle on

spa shell.

Wash pillow(s) in a mild detergent soap and warm water solution. Never machine wash your pillows

or attempt to clean them with a non-approved vinyl cleaning agent!

To reinstall pillows: Simply align pillow over mounting stud receptacle, then gently push inward to

snap in place.