beautypg.com

0 automatic filtration cycles, 1 standard filtration/heating modes (f0-f3), 2 economy filtration/heating modes (f4-f6) – Sundance Spas CONSTANCE 6530-512X User Manual

Page 36: 3 lock modes (l1-l2)

background image

Page 32

ELITE SERIES

10.0 Automatic Filtration Cycles

Your new spa includes a circulation pump that filters the water

continuously for 8 hours (default setting). The circulation pump draws

water through the short side of the double-ended filter cartridge and

effectively removes small debris in your spa.

Note: The pump is not programmable. To set a time for the circulation

pump filtration cycle, simply turn power on to the spa two minutes prior to

the desired time.

The control system activates a programmable “standard” or “economy”

filtration/heating cycle to remove larger debris missed by the circulation

pump filtration system. These cycles utilize pump #1 and the larger

filter cartridge end to quickly clear “skim” the water of large debris and

minimize their “bath-tub ring” effect. Apart from their filtration benefit,

each mode also effects the operation of your spa’s heater. Refer to

Sections 10.1 and 10.2 below for additional information.

10.1 Standard Filtration/Heating Modes (F0-F3)

Standard filtration/heating modes are typically selected by customers in

cold climates where heat up times are extended due to lower ambient

temperatures. In these modes, the set temperature regulates the water

temperature. The jets pump 1, circulation pump, and heater activate as

needed. After the programmed set temperature is reached, the heater

turns off and the spa continues its normal operations.

10.2 Economy Filtration/Heating Modes (F4-F6)

Economy filtration/heating modes are typically selected by customers in

warm climates where heat up times are minimized due to higher ambient

temperatures. In these modes, the set temperature regulates the water

temperature. The jets pump 1, circulation pump, and heater only activate

while a programmed filter cycle is running (unless in summer logic; see

Section 13.1, page 44).

Note: These modes consume less energy than standard modes F0-F3

outlined above.

10.3 Lock Modes (L1-L2)

These modes are designed for use during spa service or to prevent

unauthorized use.