Sundance Spas CONSTANCE 6530-512X - Manual (Page 19)

Page 15
ELITE SERIES
7.0 Spa Fill Up Procedure
For best results, read each step in its entirety before proceeding with that
step.
1. Prepare The Spa For Filling
Clear all debris from the spa. (Although the spa shell has been •
polished at the factory, you may want to treat it with a specially
formulated spa cleaner.) Consult your dealer for additional
information prior to filling spa.
Remove filter lid (page • 22 and 25), then remove filter cartridge
from filter bucket as illustrated in Section 11.1 (pages 35-36).
2. Fill Spa
Place the en • d of your garden hose into the empty filter bucket.
CAUTION: TO dECREASE bUILd UP ON COMPONENTS ANd
MINIMIZE ACRYLIC dAMAGE.
Never fill with water from a water softener. If your water is extremely
“hard”, it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
!
•
WARNING:
TO dECREASE RISK OF INFECTION OR
dISEASE.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments. Fill until water covers all jets but does not
touch the bottom of the lowest headrest. (DO NOT OVERFILL!)
BLUE
BLUE
BROWN
BROWN
1
2
North American Models:
240 VAC, 3-Wire Connection (60 Hz)
Figure-D
TB1
All Export Models:
230 VAC, 3-Wire Connection (50 Hz)
to Circuit
Board
BLK
RED
Power In
RED
RED
BLK
BLK
1
2
Figure-C
TB1
to Circuit
Board
Power In
Green
TB3
Green
TB3