Sundance Spas CONSTANCE 6530-512X User Manual
Page 20
Page 16
ELITE SERIES
IMPORTANT: Always fill your spa through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove the hose
and replace the filter cartridge as illustrated in Section 11.1 (pages
3.
Turn On Power
Turn on power to spa at the home’s circuit breaker to start boot up
sequence (Section 9.0, page 28). The heater and filter/circulation
pump will automatically activate after several seconds. If the control
panel LED flashes water temperature and “COOL” or “ICE” this is
normal. Refer to page 45 for additional information.
4.
Activate jets Pumps
Turn on all jet(s) pumps to ensure proper mixing when
adding start-up chemical in step 5.
5.
Add Start-Up Chemicals
Add the spa water chemicals as recommended by your Sundance
dealer. See Section titled “Water Quality Maintenance” (page 42) for
general guidance.
WARNING:
RISK OF POISONING OR dEATH.
Never leave chemicals opened and accessible to anyone.
Use chemicals according to the vendors instructions.
Always store chemicals in a safe and/or locked location.
Keep away from and out of reach of children.
!
6.
Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine
or 2.0-4.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool and Spa Professionals/USA printed on the
inside cover of this manual. If sanitizer levels cannot be stabilized,
perform the decontamination procedure steps 9-15 on the following
page.
Note: The “decontamination procedure” steps 9-15 should also be used
after the spa has been “Winterized” (Section 11.7, page 40) or has been
sitting without power for an extended period.
2
1