SUPER MICRO Computer X7SBL-LN1/LN2 - Manual (Page 45)

Chapter 2: Installation
2-27
USB Wake-Up
Use JPUSB jumpers to enable the function of
"System Wake-Up via USB devices", which al-
lows you to "wake-up" the system by pressing a
key on the USB keyboard or by clicking the USB
mouse of your system. The JPUSB jumpers are
used together with the USB Wake-Up function in
the BIOS. Enable both the jumpers and the BIOS
setting to allow the system to "wake-up via USB
Devices". See the table on the right for jumper
settings and jumper connections. (JPUSB1 is
for Back Panel USB ports:0/1, and JPUSB2 is
for Front Panel USB ports:2/3/4/5/6.)
Note: The default jumper setting for the
USB ports located on the back panel is
"Enabled". However, when the "USB Wake-
Up" function is enabled in the BIOS and
the desired USB ports are enabled via the
JPUSB jumper, please be sure to remove
all USB devices from the USB ports whose
USB jumpers are set to "Disabled" before
the system goes into the standby mode.
A. JPUSB1
B. JPUSB2
JPUSB1 (Back Panel USB
Wake-up)
Pin# Defi nition
1-2 Enabled (*default)
2-3 Disabled
JPUSB2 (Front Panel USB
Wake-up)
Pin# Defi nition
1-2 Enabled
2-3 Disabled (*default)
B
A