beautypg.com

Failures – Smeg 185426 User Manual

Page 29

background image

185426

If the washing machine identifies failures in the operation, it reports it

immediately. Sound alarm is heard and the display reads ERROR. Number

identifies the type of failure.

In some cases you may attempt removing certain failures yourself (see the

chart below), and the machine will continue to perform the operation after

pressing the START knob (F). The machine signals failures immediately after

detecting them and stops the program, except for heater failure, where the

machine completes the washing program without heating water (FAILURE 1).

In case the machine signals faults number you have to wait for

at least 2 minutes before you can open the door of the washing

machine.

Interferences from the ambient (for example electrical wiring) could induce

signalization of different faults. In such cases:

- switch the appliance off, and wait for a few seconds;

- switch the appliance back on and repeat the washing program.

If the fault repeats, call authorized service shop.

Warranty shall not apply in case of failures due to interferences from the

environment (lightning stroke, power supply circuit faults, natural disasters).

29

Failure

Possible cause

Remedy

The machine does

not work

(display is not

illuminated).

Machine is not powered.

Check if:

• plug is in the socket,

• there is power in the socket,

• the fuse is OK.

Water does not

enter the machine.

Filter is not tightly screwed in.

Inlet pipe is not tightly

screwed to the machine or to

the water faucet.

Outlet pipe fell to the floor.

Tighten the filter properly.

Tighten the inlet pipe.

Affix the outlet pipe to the drain.

The machine

moves during

operation.

The machine is not properly

leveled.

Transport brackets are not

removed.

Level the machine with the

adjustable legs.

Remove transport brackets.

The machine

vibrates during the

spin.

Unevenly distributed laundry,

especially with very small

quantities (for ex. only the

bathrobe).

This is normal, the machine will

reduce the RPM if vibrations are

too strong. Wash larger quantity

of laundry.

Failures