Smeg 185426 - Manual (Page 15)

185426
in bold (spin RPM, extra rinse, higher level (HWL),
sound signal). Using the SELECTOR water knob (C)
you may change settings. Activation of a particular
function is confirmed by the relevant symbol
appearing on the display. Function is deactivated by
another pressing the SELECTOR knob (C).
Reduced spin RPM / Rinse hold
Best recommended spin RPM for the selected
program appear on the display. Using the button (C)
in some models you can increase the selected RPM
(1300-1800) or reduce in steps till “0”, when all
spins are off. Last selector is “pump stop” meaning
that laundry will remain soaked in the last rinse
water.
RINSE HOLD function is selected if you want the
laundry not to be excessively creased in case you
are unable to remove it from the drum immediately
after the end of washing cycle. This is specially
handy for washing of synthetics and delicate
laundry . However, it is not recommended for
wool or hand wash .
Extra rinse/ Water clean sensor
This function is for persons, especially sensitive to
detergents. Using the SELECTOR knob (C) you
may select one or two extra rinses, or activate
the water clean sensor (S) - certain models only.
By activating extra rinse the display indicates
adequately increased quantity of water. If the water
clean sensor is activated, the display indicates the
symbol “S” instead of water quantity. In such cases
the machine will select appropriate number of rinses
in relation to how clean is rinsing water, detected
(measured) by the sensor.
Higher water level (HWL)
For washing heavily stained laundry.
Using the SELECTOR knob (C) you may increase
quantity of water for rinsing. For certain programs
15