Smeg ALFA41VEK - Manual (Page 11)

Instructions for the User
4.7 Modifying a previously edited program
To modify one of the programs, turn the knob to one of the programs from
P4 to P8 edited previously.
The parameters saved earlier will appear on the display.
Keep STOP pressed for 2 seconds.
The display shows UprH.
Press START to increase the pre-heating temperature.
Press STOP to move on to displayng the next parameter.
The display shows U t°C.
Press START to display the cooking temperature.
Press START or keep it pressed to increase the cooking temperature;
each time START is pressed the temperature increments by 1°C (from
50° to 250°), or hold START down for increments of 5°C.
Press STOP to move on to displaying the next parameter.
The display shows U Ct.
Press START to display the cooking time.
Press START or keep it pressed to increase the cooking time (from 1 min.
to 99 min.).
Press STOP to move on to displaying the next parameter.
The display shows H
2
O.
Press START to increase the number of seconds of water infeed per
minute (from 0 to 5 where 0 means conventional fan-mode cooking
without the aid of humidification).
Press STOP to complete the editing operation.
The display shows UEnd.
The parameters set are now saved in the chosen program.
4.8 Programmed preheating P9
This program, which can be edited by the user, allows the oven to be
programmed to perform a preheating operation, with the starting time,
temperature and program end time set as required.
4.9 Setting "programmed preheating"
The first step is to make sure that the oven's main clock is set to the
correct time; otherwise, adjust it as described in the SETTING THE TIME
section
N.B. - if the time has not been set (flashing), this program will not
run.
Use the knob to select the "programmed preheating" program (P9).
The display shows PrEh.
Keep STOP pressed for 2 seconds.
The display shows a flashing On message (program start time setting).
Press START or keep it pressed to increment the hours.
Press STOP to move on to setting the minutes.
31