Sony VIDEO Plus RDR-HX720 - Manual (Page 97)

97
Addi
tion
al
I
n
fo
rm
at
io
n
Additional Information
Troubleshooting
If you experience any of the following
difficulties while using the recorder, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your nearest
Sony dealer.
The power does not turn on.
, Check that the mains lead is connected
securely.
There is no picture.
, Re-connect all connecting cords securely.
, The connecting cords are damaged.
, Check the connection to your TV (page 12).
, Switch the input selector on your TV (such
as to “VCR”) so that the signal from the
recorder appears on the TV screen.
, Check that “Scart Setting” in the “Video”
setup is set to the appropriate item that
conforms to your system (page 88).
, If you connect the recorder to your TV via
only the COMPONENT VIDEO OUT
jacks, set “Component Out” in the “Video”
setup to “On” (page 87).
, This recorder cannot record NTSC signals.
, When playing a double-layer DVD, the
video and audio may be momentarily
interrupted at the point where the layers
switch.
Picture noise appears.
, If the picture output signal from your
recorder passes through your VCR to get to
your TV, or if you are connected to a
combination TV/VIDEO player, the copy-
protection signal applied to some DVD
programmes could affect picture quality. If
you still experience this problem even when
you connect your recorder directly to your
TV, try connecting your recorder to your
TV’s S VIDEO input.
, You have set the recorder to progressive
format even though your TV cannot accept
the progressive signal. In this case, hold
down x, and press PROGRAM – (minus)
on the unit.
, Even if your TV is compatible with
progressive format (525p/625p) signals, the
image may be affected when you set the
recorder to progressive format. In this case,
hold down x, and press PROGRAM –
(minus) on the unit and the recorder is set to
normal (interlace) format.
, You are playing a DVD recorded in a colour
system that is different from your TV.
, Noise may appear in the pictures recorded
on the HDD, which is due to the
characteristics of HDD, and is not a
malfunction.
, When playing a double-layer DVD, the
video and audio may be momentarily
interrupted at the point where the layers
switch.
There is no picture or the picture noise
appears when connected to the DV IN
jack.
, Try the following:
1 Turn the recorder off and on again.
2 Turn the connected equipment off and on
again. 3Disconnect and then connect the
i.LINK cable again.
TV programme reception does not fill the
screen.
, Set the channel manually in “Channel
Setting” in the “Basic” setup (page 82).
, Select the correct source using the INPUT
SELECT button, or select a channel of any
TV programme using the PROG +/–
buttons.
Power
Picture
,continued