SUUNTO n6HR - Manual (Page 34)

34
5.2. CHARGING THE BATTERY
If your Suunto n6
HR
has a remaining battery charge of 30% or less, you should
charge it as soon as possible. Charging the Suunto n6
HR
takes up to 5 hours.
To charge your Suunto n6
HR
:
1. Connect the USB cable to the adapter. Plug the adapter into an electrical outlet.
2. Connect the USB cable’s data snake to your Suunto n6
HR
.
3. Wait for the Suunto n6
HR
to fully charge. The message “
CHARGED
” is displayed
when the battery is fully charged.
NOTE: You can also charge your Suunto n6
HR
directly from your PC via the USB
cable but first you need to install the USB software. The USB software installation
package is on the CD delivered with your Suunto n6
HR
. See Chapter 6. for installation
instructions.
5.3. REPLACING THE BATTERY OF THE TRANSMITTER BELT
The transmitter belt operates on a 3-Volt lithium cell, type: CR 2032. The average
expected battery life of the transmitter belt is 300 hours of use in ideal operating
temperatures.
If your Suunto n6
HR
does not receive a signal when the transmitter belt is active, you
might need to replace the battery.