Sanyo PLC WXU700A - Manual (Page 30)

30
Choose Computer 1 by pressing the INPUT button on the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
1
Input Menu
3
Input Source Selection (Computer 1: RGB / Component / RGB(Scart) )
Computer Input

Note:
When the Input Search function is set to On1 or On in
the Auto setup function, the input signal will be searched
automatically (p.48).
Computer
1
Top Control
INPUT button
Direct Operation
Menu Operation
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select Computer 1 and
then press the Point ► button to access the submenu
items.
When Computer 1 is selected, use the Point ▲▼
buttons to select RGB and then press the SELECT
button.
COMPUTER button
Remote Control
Computer 1
Computer 
Computer 1
HDMI
Computer 
S-video
Network
Video
 COMPUTER can not be selected when using the COMPUTER IN 2/
MONITOR OUT terminal as MONITOR OUT output.