Sanyo PLC WXU700A - Manual (Page 14)

14
Part Names and Functions
Spotlight
Pointer Function
Pointer
Laser Pointer Function
LASER button
PRESENTATION POINTER
button
This remote control emits a laser beam from the laser light window. Press the LASER button to activate the
laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is
pressed for more than one minute or if it is released, the laser light goes off.
The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself or
other people. The following is the caution label for the laser beam.
CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure. Never look directly into the laser light window while a laser
is emitted, otherwise eye damage may result.
The caution label is put on the remote control.
You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the
projected image.
Press and hold the MENU and the NO SHOW buttons
for more than 5 seconds to activate the Pointer function.
(The Laser pointer has switched to the Pointer function.)
1
Press the LASER button on the remote control pointing
toward the projector. The Spotlight or Pointer is
displayed on the screen with the LASER button lighting
green. Then move the Spotlight or Pointer with the
PRESENTATION POINTER button. If the LASER button
does not light green and continues to emit a laser beam,
try the abovementioned procedure until the LASER
button lights green.
To clear the Spotlight or Pointer out the screen, press
the LASER button pointing toward the projector and see
if the LASER button lighting is turned off.
To switch to the Laser pointer again, press and hold the
NO SHOW and MENU buttons for more than 5 seconds
or slide the RESET/ON/ALL-OFF switch to RESET and
then to ON.
When you reset the Pointer function, the remote control
code will be reset, as well.
3
 Note:
You can choose the size of Spotlight (Large/Middle/
Small) and the pattern of Pointer (Arrow/Finger/Dot) in
the Setting Menu. See “Pointer” on page 54.
After the Laser pointer has
switched to the Pointer, use
the LASER button as the
Pointer function ON-OFF
switch. Press the LASER
button pointing toward the
projector and see if it lights
green.
Laser Light Window
Signal Emission Indicator
MENU button
NO SHOW button
Press and hold the MENU
and NO SHOW buttons for
more than 5 seconds.
PRESENTATION POINTER
button
ない。