Sanyo PLC WXU700A - Manual (Page 28)

8
Basic Operation
Remote Control Operation
Using the remote control for some frequently used operations is advisable. Just pressing one of the buttons
enables you to make the desired operation quickly without calling up the On-Screen Menu.
Press the HDMI, COMPUTER, VIDEO or NETWORK button
on the remote control to select the input source. See pages
30-31, 40-41 for details.
Refer to the owner’s manual of “Network Set-up and
Operation” for details about the network input.
HDMI/COMPUTER/VIDEO/NETWORK button
Press the FREEZE button on the remote control to freeze
the picture on the screen. To cancel the Freeze function,
press the FREEZE button again or press any other button.
Fig.1 will appear on the Screen menu while the Freeze
function is working.
FREEZE button
Display the input source information: Input, H-sync freq .,
V-sync freq ., Screen, Language, Lamp status, Lamp
counter, Power management, Key lock, PIN code lock
and Remote control (p.63).
INFO . button
Press the D.ZOOM +/- buttons on the remote control to
enter to the Digital zoom +/– mode. See page 39 for details.
D .ZOOM +/- buttons
Remote Control
FREEZE button
D .ZOOM+/-
buttons
INFO .
button
POINT ▲▼buttons
LAMP
button
 Note:
See the next page for the description of other
buttons.
LAMP button
COMPUTER
button
NETWORK
button
VIDEO button HDMI button
PIP button
Press the PIP button on the remote control to enter P in P
or P by P.
Mode of Picture in Picture and input source will be displayed
on the main picture and input source will be displayed on the
sub picture for 10 seconds.
See page 55 for details.
PIP button
Press the LAMP CONTROL button on the remote control
to select the lamp mode for changing the brightness on the
screen.
Auto .......... The brightness according to the input
signal (between High and Eco mode).
High .......... Brighter than the Normal mode.
Normal ...... Normal brightness
Eco ............ Lower brightness reduces the lamp power
consumption and extends the lamp life.
Fig.1