Woodstock W1828 - Manual (Page 19)

Model W1828 (For Machines Mfg. Since 4/11)
-17-
O
PE
R
ATIO
NS
Disabling ON/OFF Switch
Figure 12. Removing switch key from
paddle switch.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised oper-
ation. To help prevent unsupervised
operation, disable the switch before
leaving the machine unattended! Place
the switch disabling key in a well-hid-
den or secure location.
The ON/OFF switch can be disabled by removing the
switch disabling key, as shown in Figure 12. Disabling the
switch in this manner can prevent unauthorized operation
of the machine, which is especially important if the
machine is not stored inside an access-restricted building.
IMPORTANT: Disabling the switch by removing the key
only restricts its function. It is not a substitute for
disconnecting power from the machine when adjusting or
servicing.
Operation Overview
The purpose of this overview is to provide the novice
machine operator with a basic understanding of how
the machine is used during operation, so the machine
controls/components discussed later in this manual are
easier to understand.
To complete a sanding operation, the operator does
the following:
1. Examines the workpiece to make sure it is suitable
for sanding.
2. Adjusts the table tilt if necessary and locks the table
in place.
3. If necessary, inserts the miter gauge in the miter
slot, adjusts the miter gauge to the required sanding
angle, and locks it in place.
4. Wears safety glasses and a respirator.
5. Starts the machine and dust collector.
6. Holds the workpiece firmly and flatly against both
the table and miter gauge (if used), pushes the
workpiece into or along the sanding disc, and moves
it to different locations to wear the sandpaper
evenly and prevent it from overheating.
7. Stops the machine.
Damage to your eyes and lungs could
result from using this machine without
proper protective gear. Always wear
safety glasses and a respirator when
operating this machine.