Woodstock W1828 - Manual (Page 18)

Model W1828 (For Machines Mfg. Since 4/11)
-16-
O
PE
R
ATIO
NS
OPERATIONS
General
This machine will perform many types of operations
that are beyond the scope of this manual. Many of these
operations can be dangerous or deadly if performed
incorrectly.
The instructions in this section are written with the
understanding that the operator has the necessary
knowledge and skills to operate this machine. If at any
time you are experiencing difficulties performing any
operation, stop using the machine!
If you are an inexperienced operator, we strongly
recommend that you read books or trade articles, or seek
training from an experienced operator before performing
any unfamiliar operations. Above all, your safety should
come first!
READ and understand this entire instruc-
tion manual before using this machine.
Serious personal injury may occur if
safety and operational information is not
understood and followed. DO NOT risk
your safety by not reading!
Basic Controls
Refer to Figure 11 and the following descriptions to
become familiar with the basic controls of this machine.
ON/OFF Switch. Turns the motor ON when flipped up;
turns motor OFF when pressed down.
Switch Disabling Key. Disables the switch when the
yellow key is removed.
Table Tilt Lock Handles. Locks the table in place. To tilt
the table, loosen the handles, tilt the work table to the
desired angle, then re-tighten the handles.
Note: The work table should be set approximately
1 ⁄
16
" away from the sanding disc to prevent fingers or
workpieces from getting caught. To adjust the work
table relative to the sanding disc, refer to in Table/Disc
Parallelism on Page 23.
Miter Gauge. Moves workpieces into the sanding disc
at a specific angle. To use the miter gauge, slide it into
the miter slot, loosen the lock knob, set the angle, then
re-tighten the knob.
Figure 11. Basic controls.
Table Tilt Lock Handle
(1 of 2)
ON/OFF Switch
w/Switch Disabling Key
Miter
Gauge