Woodstock SHOP FOX W1829 - Manual (Page 18)

-16-
Df[\cN(/)0D]^%J`eZ\0&((
J<
K
L
G
The W1829 has a built-in dust collection fan and chip
exhaust. It also includes a 2.5" dust port, clamp, and dust
collection bag. The W1829 can also be hooked up to a
pre-existing dust collection system.
I\Zfdd\e[\[:=DXk;ljkGfik1%%%%%%%%%%%%%%%% (,':=D
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the
dust port, you must take into account many variables,
including the CFM rating of the dust collector, the length
of hose between the dust collector and the machine, the
amount of branches or Y's, and the amount of other open
lines throughout the system. Explaining this calculation
is beyond the scope of this manual. If you are unsure of
your system, consult an expert or purchase a good dust
collection "how-to" book.
;ljk:fcc\Zk`fe
=`^li\(-. Installing the dust port.
=`^li\(.% Attaching the dust collection
bag.
Kf`ejkXcck_\[ljkgfikXe[Zfcc\Zk`feYX^#[fk_\j\
jk\gj1
(% Install the dust port to the chip exhaust, as shown in
=`^li\(-%
)% Slip the bag clamp over the collection bag, then
attach the collection bag to the dust port and clamp
it in place, as shown in
=`^li\(..
;F EFK fg\iXk\ k_`j dXZ_`e\ n`k_$
flk Xe X[\hlXk\ [ljk Zfcc\Zk`fe jpj$
k\d% K_`j dXZ_`e\ Zi\Xk\j jlYjkXek`Xc
Xdflekjf]nff[[ljkn_`c\fg\iXk`e^%
=X`cli\kflj\X[ljkZfcc\Zk`fejpjk\d
ZXei\jlck`ej_fikXe[cfe^$k\idi\jg`$
iXkfip`cce\jj%
For your convenience, the adjustments listed below have
been performed at the factory and no further setup is
required to operate your machine.
However, because of the many variables involved with
shipping, we recommend that you at least verify the
following adjustments to ensure the best possible results
from your new machine.
Step-by-step instructions for these adjustments can be
found in Service on Page 28.
1. Knife settings (see Page 30).
2. Fence stop accuracy (see Page 33).
I\Zfdd\e[\[
8[aljkd\ekj