Smeg SC110NE - Manual (Page 9)

40
Instructions for the User
7.3 First use
At first use, or after a power failure, the oven's left hand-display, DSP1, will
show a flashing symbol. To start any cooking operation, the current
time must be set.
7.3.1 Setting the current time
To set the current time, turn PT1 to the right and left to increase or
decrease the hours. Press it once to move on to setting the minutes. Turn
it the right and left to increase or decrease the minutes and press it to set
the current time. The symbol will appear on the display, which will stop
flashing.
7.3.2 Changing the current time
It might become necessary to change the current time, for example at the
switch from summer to winter time. To do this, starting from the standby
setting (see point “7.2 Operating modes”) keep PT1 pressed until the
figures on DSP1 flash. Now repeat the operations described in point “7.3.1
Setting the current time”.
7.4 Selecting the function
In the ON state only, a cooking function can be selected by simply turning
PT2 to the right or left. The function selected will change colour to red on
DSP3. The preset cooking temperature will be displayed on DSP2.
7.4.1 Cooking with preset temperature
After selection of the function required, the oven will start the cooking
procedure at the preset temperature. Cooking itself is preceeded by a
preheating stage, which allows the oven to heat to the cooking
temperature more quickly. The ° symbol flashes on DSP2 to indicate that
this stage is in progress. The symbols will light up one at a time, from
the bottom up, indicating the rise in the temperature inside the oven. When
the preheating stage is over, the ° and symbols will remain constantly
on to indicate that the food can be placed inside the oven.
7.4.2 Changing the preset temperature
The temperature preset for each function can be changed to suit the user's
requirements.
At any time while cooking is in progress, turn PT1 in either direction to
increase or decrease the cooking temperature by 5 degrees at a time. PT1
can also be held in the left or right position to increase or decrease the
setting more quickly.