Samsung CLX-318X - Manual (Page 64)

Media and tray_ 3
1. Pull the tray out of the machine. Open the paper cover and remove
paper from the tray if necessary.
2. Pressing and unlatching the guide lock in the top of the tray, pull the tray
out manually.
3. Place paper with the side you want to print facing up.
4. Slide the paper length guide until it lightly touches the end of the paper
stack. Squeeze the paper width guide and slide it to the edge of the
paper stack without causing it to bend.
For paper smaller than Letter-sized, return the paper guides to their
original positions and adjust the paper length guide and paper width
guide.
If the paper that you need to print is shorter than 222 mm (8.74 inches),
press and unlatch the guide lock in the tray. Unextend the tray by
pushing manually the extended portion back into the tray. Adjust the
paper length guide and paper width guide.
• Do not push the paper width guide too far causing the media to
warp.
• Do not use a paper with more than 6 mm (0.24 inch.) curl.
• If you do not adjust the paper width guide, it may cause paper
jams.
5. Close the paper cover.
Slide the tray back into the machine.
After loading paper, set the paper type and size for the tray (See "Setting
the paper size and type" on page 6).
• Due to insufficient paper in the tray, the paper length guide can be
pushed to inside, load paper enough.
• If you experience problems with paper feed, load a paper into the
tray one by one.
• You can load previously printed paper. The printed side should be
facing up with an uncurled edge at the front. If you experience
problems with paper feed, turn the paper around. Note that
print quality is not guaranteed.
1
1
2