Sharp MD-MT821 - Manual (Page 31)

n To change disc names or track
names
Some MiniDiscs created on other equip-
ment may have more than 100 characters
in a track name or disc name. The charac-
ters from the 101 st character and on can-
not be corrected or changed.
To delete characters:
1
Put the unit in the character input mode.
To delete characters in a disc name,
perform steps 1 - 2 on page 28.
To delete characters in a track name,
perform steps 1
-
3 on page 29.
2
Press the VOL + or VOL - button to
move the cursor to the character you
want to delete.
3
Press the BASS button.
The character will be erased.
4 Press the EDIT button.
To add characters:
1
Put the unit in the character input mode.
To add characters to a disc name, per-
form steps 1 - 2 on page 28.
l
To add characters to a track name,
perform steps 1
-
3 on page 29.
2
Press the VOL + or VOL button to
move the cursor to the right of the char-
acter, where you want to add a new char-
acter.
3
Preform steps 3 - 5 in the “Disc name”
section.
4
Enter the new character you want, and
press the EDIT button.
n Name/stamp
Master MiniDisc
(Prerecorded
2. The character
information, such as the
disc name and track
names is transferred
MiniDisc
1
Record the sound from the master
MiniDisc onto a recordable MiniDisc.
Playback unit Recording unit
Master MiniDisc Recordable MiniDisc
Refer to the standard recording
method. (Pages 8 - 14)
At this point, only the sound is re-
corded. No character information is
transferred.
Check whether the total number of
tracks on the newly recorded MiniDisc
matches the total number of tracks on
the master MiniDisc. If they do not
match each other, combine or divide
tracks using the edit operation.
(Pages 27 - 28)
l
This function can not be performed
from playback only MiniDiscs.
2
When the recording is complete, remove
the newly recorded MiniDisc and load
the master MiniDisc into the MD-MT821.
Do not mistake the master MiniDisc
for the newly recorded MiniDisc.
30