Sharp MD-MT821 - Manual (Page 11)

n Recording from CDs or MDs (Synchro recording)
Svnchro recording is a method that detects the playback sound from the source equip-
ment. When sound is present, it automatically s t a r t s recording. When the sour&is
silent, the recordina will be paused
1. connect the external equipment.
(See page 8.)
. Insert a recordable MiniDisc.
3 Press the REC button.
To record from a tuner, first tune in a
broadcast.
To record from a CD, first start play-
ing the track you want to record.
4
While playing sound from the external
equipment connected to this unit, move
the
REC LEVEL shuttle switch
to adjust the recording level.
5
6
Adjust the recording level so that the
maximum sound volume from the
source makes the reading swing
somewhere between -4 dB and 0 dB.
To record from a CD, first adjust the
recording level. Then put the equip-
ment connected to this unit into the
playback stand-by mode.
Press the ENTER/SYNC button.
Begin playback on the source equip-
ment.
Recording will begin automatically.
To interrupt recording:
When the source equipment is stopped,
the unit will enter the synchro recording
stand-by mode. When playback is re-
sumed, a recording will be resumed.
If a silence lasts for 3 seconds or more,
the recording will be paused.
Pressing the button on this unit
(when in this mode) will cause the unit
to enter the recording stand-by mode
and cancel the synchro recording mode.
To stop recording:
Press the button.
If the unit is left unattended after the
recording is complete, the power will
automatically shut off in approximately
2 minutes.
-4dB
10