Sharp MD-MT821 - Manual (Page 23)

To interrupt playback:
Press the button during playback.
To resume playback, press the but-
ton again.
To stop playback:
Press the
n
/:OFF button.
To turn off the power:
Press the
n
/:OFF button while in the stop
mode.
If the unit is not operated for at least 2
minutes while in the stop mode. the
power will shut off automatically.
To remove the MiniDisc:
Turn off the power and move the OPEN le-
ver in the direction indicated by the arrow.
Resume auto play function:
When you press the
n
/:OFF button to
stop playback, or when you turn the
power off and then you resume play-
back, it will resume at the point on the
MiniDisc where the playback was halted.
If the MiniDisc is removed and inserted,
and playback is resumed, playback will
start from the first track.
Precautions when making connec- Caution:
tions: When the unit is not to be used imme-
Do not use any remote control unit, diately after a MiniDisc has been in-
except for the one included with this serted, or when you plan to carry the
unit. unit, turn off the power or cancel the
Do not remove the rubber pads from auto-play function. Otherwise, the
the headphones.
auto-play
function will be activated and
Insert each plug securely, all the way the battery will run down.
in. Since the main unit and the AC adap-
Be sure to hold the plug when remov- tor can heat up during use, you should
ing it. If you pull on the cord, it may avoid allowing the unit to be in direct
break, or the unit may malfunction. contact with your skin for any length
Interrupted sound:
of time.
This product is designed to eliminate When using the unit with a car adaptor:
interruptions in the sound which can When you switch off the ignition key
be caused by vibrations. However, if during playback, the power to this unit
the unit is continuously exposed to will also be turned off. Then, when the
vibrations or mechanical shock, the ignition key is switched on, playback
sound may be interrupted momen- will star-l from the beginning of the track
tarily. where playback was halted (Resume
When the sound is distorted:
auto-play function). However, the
If the volume is too high while the bass
power to the unit may not be turned
is being emphasized, the sound may
off when the ignition is turned off, de-
be distorted, depending on the music
pending on the type of car.
on the track. If this happens, decrease ,
the bass level or lower the volume
level.
If the volume is increased to “VOL 24
or higher, the bass level will be ad-
justed automatically.
(This is done to reduce the distortion
in the sound.)
2 2