Sony Portable MD Recorder MZ-RH710 - Manual (Page 68)

68
model name1[MZ-RH710] model name2[MZ------]
[2-593-568-11(2)]
masterpage:L0-Left
filename[E:\SONY
PA\5252_RH710\REVISE\DATA\J9050645_2593568112RH710_GB\2593568112\01GB
-MZ-RH710EE\04GB0OPE.fm]
Troubleshooting and explanations
Troubleshooting
If a problem occurs during recorder operation, follow the steps described below before
consulting the nearest Sony dealer. If any messages appear, it is recommended to take
notes.
1
Check to see if the problem is listed in, “Troubleshooting” (page 68).
Check “Messages” (page 76) for the problem as well.
2
If after step 1 you still cannot solve the problem, consult your nearest Sony dealer.
While recording
Symptom Cause/Remedy
“NotENOUGH
POWER TO REC”
appears and recording
cannot be done on a
1GB Hi-MD disc. • Recording is not possible when using a 1GB Hi-MD disc even
when the battery level indication shows enough power remaining
while the recorder is stopped or playing. This is because of a
mechanism that disables recording when the remaining battery
power is estimated by the recorder to be insufficient due to the high
power consumption required for 1GB Hi-MD disc recording.
, Insert a new alkaline dry battery or connect the AC power
adaptor (not supplied) to the recorder.
The remaining
recording time appears
as “–00:00” and
recording cannot be
done, even though
2.0MB of free space is
displayed. • This is a system limitation. 2.0MB is the capacity of the reserve
domain.
The recorder always
creates a new group
when recording. • The group recording (“ :REC”) is set to “ :REC On”. (You
cannot overwrite tracks.)
, Set the group recording setting to “
:REC Off” (page 33).
The first few seconds of
a track cannot be
recorded. • If you start recording while the disc indication is rotating, data will
not be recorded to the first few seconds of the first track.
, Wait until the disc indication stops rotating before you start
recording.
020REG.book Page 68 Tuesday, April 12, 2005 11:18 AM