Sharp MD-X8 - Manual (Page 18)

17
0049
COMPACT DISC OPERATION
H H H H H
Loading and playing CD
1 Press the CD
H
button.
I
The power will be turned on automatically,and the unit will enter the
CD playback mode.
2 Press the
7
button to open the disc tray.
I
It is impossible to open multiple disc trays at a time.
3 Place the CD (s) on the disc tray, with the labeled side facing
up.
I
Be sure to place 8 cm (3" ) CDs in the middle of the disc holders.
Caution:
Do not stack CDs in the tray.
This can damage the player and the CDs.
4 Press the
7
button to close the disc tray.
I
The total number of tracks and the total disc playing time will be
displayed.
5 Press the CD
06
button.
I
Playback will begin from track 1 on DISC -1.
I
DISC-1, DISC-2 and DISC-3 will be played continuously in that order.
I
If you press the CD PLAY 2 button after pressing the CD
06
button,
DISC-2 and DISC-3 will be played continuously.
I
If you press the CD PLAY 3 button after pressing the CD
06
button,
only DISC-3 will be played.
I
When all of the tracks on the CDs completed playing, it stops
automatically.
I
After the disc finishes playing, the next disc will be automatically
played.
I
When there is no CD in one of the disc trays, that tray will be skipped,
and the next CD will be played.
Direct playback:
When a CD is loaded in the disc tray, simply pressing any of the
CD
06
button or one of the CD PLAY buttons (1-3) on the main
unit or on the remote control will turn the power on and start
playback.
Note:
I
If the disc tray is open when you press one of these buttons, it will close
automatically.
To interrupt playback:
Press the CD
06
button.
Press the CD
06
button to resume playback from the same
point.
To stop playback:
Press the CD
H
button.
To remove the CDs:
While in the stop mode, press the
7
button.
To switch the unit off after use:
Press the POWER button to turn the power off.
WWWW
S T O P
D I S C 1
C D WWW 1 6 WWW 5 6 : 1 3 T O T A L
Number of tracks on
the selected disc
Total playing time of the
selected disc
Disc number
selected
The trays containing a CD are displayed.*
*This indicator will light even if the CD tray is opened and
closed without inserting a CD.
This indicator will go out after checking for a CD, if the tray
is empty.
To play a specific CD:
Press the button number for the CD you want from the CD PLAY buttons
(1-3) on the main unit or on the remote control.
I
Only the selected CD will be played.
Note:
I
If you press the CD
06
button on the main unit or remote control even
though you have selected DISC-2 or DISC-3 previously, continuous
playback will start from the track 1 on DISC-1.
1 2 3
PLAY
1 2 3
PLAY
1
2
3
CD
CD
*17-21 98.6.23, 0:11 PM 17