Sharp MD-X8 - Manual (Page 16)

15
(Continued)
H H H H H
Entering extra large characters
In the case of the extra large characters, the characters you
can choose from are as follows:
Each time the DISPLAY button is pressed, the character type will
change.
Each time the or on the MULTI CONTROL button is
pressed, a different series of characters will appear.
Preparation
Put the unit in the mode in which characters can be
entered.
I
To create an MD disc name, perform steps 1 - 3 of the "To creat a
disc name "section on page 36.
I
To create an MD track name, perform steps 1 - 2 of the "To creat a
track name "section on page 36.
I
To change the messages displayed when the power is turned on or off,
perform steps 1 - 3 on page 49 or on page 51.
1 Press the DISPLAY button to select the type of character you
want to enter.
I
Each time the button is pressed, the type of character will change.
2 Press the or on the MULTI CONTOROL button to move
the cursor to the character you want to enter.
3 Press the ENTER button.
4 Perform steps 1 - 3 repeatedly to enter the characters you
need.
5 After entering all the characters
For a radio station name, MD disc name, or MD track
name:
Press the NAME/TOC EDIT button.
For the messages displayed when the power is turned
on or off:
Press the MESSAGE button.
I
The characters will be stored in memory.
1
2
3
A B C D E F G H I J
A B C D E F G H I J
B
A B C D E F G H I J
A B C D E F G H I J
a b c d e f g h i j 1 2 3 4 5 6 7 8 9 0 A B C D E F G H I J
k l m n o p q r s t * #
, . ; :
_
a b c d e f g h i j
>
( )
@
K L M N O P Q R S T
<
!
?
& % $
A B C D E F G H I J
+ _ / =
, ,,
1 2 3 4 5 6 7 8 9 0
U V W X Y Z . , /
/
u v w x y z . , /
ENTER
MESSAGE
NAME/
TOC EDIT
DISPLAY
MULTI CONTROL
*01-16 98.6.23, 10:30 AM 15