Sundance Spas ALTAMAR 880 - Manual (Page 56)

Page 50
880 SERIES
When a programmed filter/heating cycle activates, the LCD screen
displays the following message :
At any time, you may check the programming of any economy mode
filter/heating cycle by first pressing (CYCLe) button then moving
through the menu by pressing either (CYCLe) or (SeLeCT)
button. The programming is changed only by pressing (UP) or
(dOWN) buttons during this process.
13.3 Adjusting Time of day
The Sentry control system remembers the time of day even in the event
of a prolonged power outage. However, it may occasionally be necessary
to reset the time of day. For example: if you are not in the Pacific Time
Zone you will want to reset the time for your own time zone. (The
system will automatically adjust to and from daylight savings time.) To
accomplish this, press (diSPLAY) , (MOde) , and (diSPLAY)
button within five seconds each. A number representing the
hour will be displayed, followed by AM or PM. The hour will advance or
decrease each time the (UP) or (dOWN) button is pressed
within five seconds. Then, press the (diSPLAY) button again
to display minutes. Adjust minutes as necessary by pressing the (UP)
or (dOWN) button. After 5 seconds, the display will return to
normal and save your settings.
13.4 Programming The date (except Maxxus)
The Sentry control system allows you program the month, day, year,
and day of the week. To accomplish this, press (diSPLAY) ,
(MOde) , and (diSPLAY) button within five seconds each.
The current hour setting will be displayed, followed by AM or PM. Then,
press the (diSPLAY) button again to display minutes. Press the
(diSPLAY) button again to adjust the month as necessary by
pressing the (UP) or (dOWN) button. Press the (diSPLAY)
button again to adjust the day by pressing the (UP) or
(dOWN) button. Press the (diSPLAY) button again to adjust
the year by pressing the (UP) or (dOWN) button. Press the
(diSPLAY) button again to adjust the day of the week by pressing
the (UP) or (dOWN) button. After 5 seconds, the display will
return to normal and save your settings.
Note: The day of the week will be represented by a number rather than
by name. The numbers will run consecutively from 1-7 with 1 = Sunday
and 7 = Saturday.
*Note: Number will vary
according to which filter
cycle is being programmed.
1*