Sundance Spas ALTAMAR 880 - Manual (Page 27)

Page 21
880 SERIES
13. Consult your authorized Sundance Spas dealer for chemical rec-
ommendations, then add chemicals to hot tub water to achieve a
constant sanitizer reading within the levels recommended by the As-
sociation of Pool and Spa Professionals printed on the inside cover
of this manual.
14. Turn on all jet pumps and the blower when adding chemicals to
ensure proper mixing and leave your hot tub cover open until the
sanitizer level falls below 4.0 ppm to protect pillows and plastic knobs
from chemical attack.
WArNiNG:
riSk OF PerSONAL iNjUrY.
To decrease the risk of injury, entrapment or drowning, •
never leave your hot tub unattended for any reason,
especially if while the cover is open and accessible to
small children and animals!
To decrease the risk of • contracting a waterborne illness
(e.g. an infection, bacteria or virus) and/or respiratory
ailments, maintain water chemistry within 6 step parame-
ters. If you or other bathers experience such a condition,
discontinue use and seek immediate medical attention.
!
15. Establish a sanitizer reading between 3.0-4.0 ppm chlorine or 2.0-4.0
ppm bromine, then allow the hot tub to set undisturbed for 8 hours.
Retest water after 8 hours to determine if sanitizer levels are stable.
If sanitizer levels are stable, your hot tub is ready for use. To ensure
healthy water conditions, always maintain a constant sanitizer
reading within the levels recommended by the Association of Pool
and Spa Professionals printed on the inside cover of this manual.
If sanitizer levels are not stable at this time, it will be necessary to
repeat this procedure in its entirety (steps 1-15) until stable sanitizer
readings are achieved.
16. After adequate sanitizer levels are achieved, close all spa air controls
by rotating them clockwise to maximize heat retention when spa is
not in use.