Sundance Spas ALTAMAR 880 - Manual (Page 36)

Page 30
880 SERIES
11.0 Operating instructions
Your Sundance® hot tub has a touch-sensitive control panel, massage
selector valves and air control knobs located on the top rim of the hot tub
(Figures F-K, pages 24-29). These controls let you operate many of the
special functions of your Sundance® hot tub. By familiarizing yourself
with the following information, you will be able to gain the full benefit
afforded by the various functions of your hot tub.
11.1
View Button
Pressing this button inverts the main four-digit display on the
Command Center’s LCD screen to allow easy reading from
either inside or outside the hot tub.
11.2
Air injection
When the Air button is pressed, the air blower forces air
through the injectors located in the seats and footwell. The
bubbles symbol on the button appears on the LCD whenever the air
blower is on. An electronic timer automatically turns the air blower off 20
minutes after it was turned on.
Note: The air blower automatically activates for 1 minute at the start of
the clean-up cycle at 12:00 (Noon). This clears the lines of the air injector
system to help ensure that all water is exposed to sanitizer. This cycle is
non-programmable.
11.3 Controlling the water temperature
Press either the COOLer ( ) or WArMer ( ) button
once to display the “set” temperature for 5 seconds. If you want
the water to heat to a different temperature, simply
press COOLer or WArMer within 5 seconds.
The set temperature increases or decreases by one
degree each time either button is pressed.
To access the overtemp feature that allows the spa
to reach 106°F (41°C) proceed with the following
steps (Figure 1). Due to a difference in software the overtemp feature is
not available for the Maxxus model. Reference Section 3.0, page 2 for
important safety instructions.
WArNiNG:
riSk OF HYPerTHerMiA (OVer-HeATiNG)
CAUSiNG SeVere iNjUrY, BUrNS, WeLTS Or deATH!
Water temperature in excess of 104°F (40°F) may be injuri-
ous to your health.
!
A
B
C
Figure 1