Smeg ALFA135BE - Manual (Page 8)

Instructions for the User
4.4 Program selection
This oven has 15 different cooking programs, including:
14 user-editable programs for fan-mode cooking (P1 to P14);
1 manual editable program for fan-mode cooking ( ).
The following table shows the parameters for each program.
Uprh
preheating
temperature
Ut °C
cooking
temperature
U Ct
cooking time
P1 Same as edited Ut°C Preset 185°C Preset 16‘
P2 Same as edited Ut°C Preset 190°C Preset 15’
P3…P14 Same as edited Ut°C Editable Editable
Same as edited Ut°C Editable Editable
4.5 How to Edit a Program
The programs the user is able to edit are from P1 to P14
A number of parameters can be edited for each program:
•
cooking temperature [U t°C] User heating
•
cooking time [U Ct] : User cooking time
To edit a program by entering the parameters exactly as required, turn the
knob to one of the programs from P1 to P14.
The display shows the parameters contained in the selected program.
Hold down STOP for 2 seconds.
A beep sounds to indicate that the editing mode has been accessed, and
the message Ut°C appears on the display.
Press START to display the cooking temperature.
Press START or keep it pressed to increase the cooking temperature;
each time START is pressed the temperature increments by 1°C (from 50°
to 300°), or hold START down for increments of 5°C.
Press STOP to move on to displaying the next parameter
The display shows U Ct.
Press START to display the cooking time.
Press START or keep it pressed to increase the cooking time (from 1 min.
to 99 min.).
Press STOP to complete the program editing procedure.
The display shows UEnd.
The parameters set are now saved in the chosen program.
Press START to display the parameters just set.
Press START again to run the program just edited.
4.6 Fan mode cooking
Use the knob to select one of the preset programs (P1 – P14).
The display shows the parameters of the selected program.
25