SMC Networks ADSL Barricade SMC7204BRA - Manual (Page 56)

Configuring DHCP Relay
53
First, you must configure your PCs to accept DHCP information
assigned by a DHCP server:
1. Open the Windows [Control Panel] and display the computer's
[Networking properties]. Configure the TCP/IP properties
to [Obtain an IP address automatically] (the actual text may
vary depending on your operating system). For detailed
instructions, see Quick Start, Configuring Your Computers on
page 9 Next, specify the IP address of the DHCP server and
select the interfaces on your network that will be using the
relay service.
2. Log into the Configuration Manager, click the [LAN] tab.
Then click [DHCP Relay] in the task bar. The [Dynamic Host
Configuration Protocol (DHCP) Relay Configuration] page
appears:
Figure 14. Dynamic Host Configuration Protocol (DHCP)
Relay Configuration Page
3. In the [DHCP Server Address] fields, type the IP address
of your ISP's DHCP server. If you do not have this number,
it is not essential to enter it here. Requests for IP information
from your LAN will be passed to the default gateway, which
should route the request appropriately.