Sanyo VPC-MZ3EX - Manual (Page 126)

QUICK SHOT SETTING
(STILL IMAGE SHOOTING MODE ONLY)
With the initial settings, when the shutter release button is pressed, the digital
camera performs the exposure correction, the white balance settings, the
focussing, and other settings before the image is captured. This results in a
delay after the shutter release button is pressed before the image is actually
captured. By turning on the quick shot setting, these settings are set less
precisely, but the delay after the shutter release button is pressed until the
image is actually captured is drastically reduced.
1
Display the Still Image Shooting
Setting Screen (see page 39).
2
Select a quick shot setting from the
quick shot menu.
ä
: Turns off the quick shot setting.
R : Turns on the quick shot setting.
3
Press the SET button.
œ This completes the quick shot
setting.
HINT
How to use the quick shot
1
Select R to turn on the quick shot setting.
2
Press the shutter release button, and when the camera is ready to shoot,
press it again.
œ The first time the shutter release button is pressed, the digital camera
performs the normal settings; the second time it is pressed, quick shot
shooting is enabled. If the shutter release button is subsequently
pressed within 1 second, consecutive quick shots are possible. After an
interval of one second or more, however, the camera returns to normal
shooting.
B 14
QUICK SHOT
OFF
SX612/EX, GX, U (VPC-MZ3 GB2) Thu. Sept., 05/2002
123
English