Sony 500WSPL - Manual (Page 45)

Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
45
Notes
• The camcorder does not support the noiseless
function of the various speed playback.
• The slow playback will be automatically released to
protect the tape if the slow playback lasts for about
one minute.
Connecting the DSR-70/70P Digital Videocassette Recorder (Optional
DSBK-140 Is Required)
You can do cut editing and digital dubbing when connecting the DSR-70/70P with fitting the optional DSBK-140,
using an i.LINK cable (DV connecting cable).
VCR Connecting cable
BVW-50/50P/35/
35P (portable) CCZ-A Camera
cable (max. length
10 m (33 ft.))
VO-8800/6800
(U-matic) CCZQ-A Camera
cable (max. length
10 m (33 ft.))
Connector
VTR connector
VTR connector
DV OUT
connector Digital
Videocassette
Recorder DSR-
20/20P/70/70P/
2000/2000P, etc. i.LINK cable (DV
connecting cable)
(max. length
4.5 m (14 ft.))
DSR-500WSL/500WSPL
DV OUT
i.LINK cable (DV connecting cable)
DV IN
DSR-70/70P Digital
Videocassette Recorder
Notes
• There is no power supply connection between the
camcorder and VCR. Provide separate power
supplies.
• The VTR connector always outputs the signals from
the camera (impossible to output the playback video
of the internal VCR), and disallows the CCU
connection.
• When no VCR is connected to the VTR connector
(26-pin), it does not supply signals.
Connecting an External VCR
You can use a following external VCR connected to
the VTR connector (26-pin) or the DV OUT connector
for recording.
• When dubbing tapes using the DSR-70/70P, a
continuous recorded section of approximately five
seconds is required before the recording start point. It
is recommended to record beforehand color bars or a
similar signal at the start point of the source tape to
be dubbed on this unit.