2 start-up 20, 1 set ting the sys tem code num ber 20, Start-up 20 - 26 – Samson Trovis 5100 User Manual
Page 20: Sys tem code num ber 20, Start-up, Setting the system code number, 2start-up 2.1 setting the system code number
2
Start-up
2.1 Setting the system code number
10 different hydraulic schematics are available. Each system configuration is represented by a
system code number. The different schematics are dealt with in section 4. Available controller
functions are described in sections 5, 6 and 7.
Changing the system code number resets previously adjusted function blocks to their default set-
tings (WE).
The system code number is set in the configuration level.
Proceed as follows:
Switch to configuration and parameter level.
Display shows: PA1
Select Anl_ on the display.
Activate editing mode for the system code number.
Anl
blinks on the display.
Edit system code number.
Confirm system code number.
Display shows: Co1
Return to the operating level.
Note!
The controller automatically returns to the operating level if the keys are left unpressed for two
minutes.
20
EB 5179 EN
Start-up