Siemens SX66 - Manual (Page 28)

SX66 User Manual 28 SX66 User Manual 29
Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecom-
munications Internet Association (CTIA) web-site at www.phonefacts.net or the Canadian Wireless
Telecommunications Association (CWTA) website www.cwta.ca
SAR information on this Siemens SX66 phone is on file with the FCC and can be found
under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on FCC ID
NM8BLUEANGEL. While there may be differences between the SAR levels of various phones
and at various positions, all Siemens products meet the governmental requirements for safe
RF exposure.
+ For body worn operation, this mobile phone has been tested and meets FCC RF exposure
guidelines when used with a Siemens accessory designated for this product, where
available, or when used with a carry accessory that contains no metal and that positions
the handset at least 1.5 cm/0.59 in from the body. Use of other carry accessories may not
ensure compliance with FCC RF exposure guidelines.
* The World Health Organization (WHO, CH-1211 Geneva 27, Switzerland), on the basis of
the actual knowledge, does not see any necessity for special precautionary measures
when using cell phones.
Further information: www.who.int/peh-emf www.mmfai.org, www.siemens-mobile.com
** averaged over 1 g of tissue.
*** SAR values may vary depending on national requirements and network bands. SAR
information for different regions can be found at www. siemens-mobile.com
Limited Warranty
This limited, non-transferable warranty is provided to the original buyer/end-consumer
(“Customer”) for handsets and accessories (“Product”) manufactured, sold and/or distributed by
Siemens Information and Communication Mobile LLC (“Siemens”). This warranty is provided by
the Seller of the Product (“Seller” shall be defined as the relevant authorized reseller or distributor
of the Product or the reseller/distributor’s warranty fulfillment partner, as applicable). Siemens
warrants to you that at the date of purchase, the product is free of defects in workmanship and
materials and the software included in the product will perform in substantial compliance to its
program specifications.
Warranty Period
The Product warranty period is one (1) year from the original date of purchase by Customer.
Exclusive Remedy
Siemens, the Sellers and Siemens’ entire liability and your exclusive remedy if the Product is defective
in materials or workmanship during the warranty period and is returned at Customer’s expense
to the original place of purchase shall be that the Product will be repaired or replaced, at Seller’s
option, at no charge. Customer will be required to show valid proof-of-purchase” (proof of date of