Southbend SB1014F - Manual (Page 70)

-64-
For Machines Mfg. Since 7/09 EVS Toolroom Lathes M A I N T E N A N C E
Machine Storage
If the machine is not properly prepared for
storage, it may develop rust or corrosion. If
decommissioning this machine, use the steps
in this section to ensure that it remains in good
condition for later use.
To prepare your machine for short-term
storage (up to a year):
1. Pump out the old cutting fluid, and flush the
lines and tank with warm, soapy water.
2. DISCONNECT LATHE FROM POWER!
3. Thoroughly clean all unpainted, bare metal
surfaces, then apply a liberal coat of way oil.
4. Lubricate the machine as outlined in the
lubrication section.
5. Cover and place the machine in a dry area
that is out of direct sunlight and away from
hazardous fumes, paint, solvents, or gas.
Fumes and sunlight can bleach or discolor
paint and make plastic guards cloudy.
6. Once or twice a month, depending on the
ambient humidity levels in the storage
environment, wipe down the machine as
outlined in Step 3.
7. Every few months, start the machine
and run all gear-driven components for a
few minutes. This will keep the bearings,
bushings, gears, and shafts well lubricated
and protected from corrosion, especially
during the winter months.
To prepare your machine for long-term storage (a
year or more):
1. Run the lathe for 10 minutes to bring the
gearboxes to operating temperature, then
drain and refill the all gearboxes with fresh
oil.
Note: During extended storage (more than two
years), any component above the oil level
may rust from condensation. We recommend
overfilling any sealed gearbox. However, over
time there will be some seepage around some
shafts and seals. If any gearbox is overfilled
make sure to put a tag on the controls as
a reminder for the maintenance person
to correct the oil level before starting the
machine. If a gearbox cannot be overfilled,
every few months manually rotate the shaft
or spindle to coat any exposed gears with oil.
2. Pump out the old cutting fluid, and flush the
lines and tank with warm, soapy water.
3. DISCONNECT LATHE FROM POWER!
4. Thoroughly clean all unpainted, bare metal
surfaces, then apply a liberal coat of way oil,
a heavy grease, or rust preventative. Take
care to ensure these surfaces are completely
covered but that the rust preventative or
grease is kept off of painted surfaces.
5. Lubricate the machine as outlined in the
lubrication section.
6. Loosen or remove machine belts so they do
not become stretched during the storage
period. (Be sure to also affix a maintenance
note near the power button as a reminder
that the belts have been loosened or
removed.)
7. Place a few moisture absorbing desiccant
packs inside of the electrical box.
8. Cover and place the machine in a dry area
that is out of direct sunlight and away from
hazardous fumes, paint, solvents, or gas.
Fumes and sunlight can bleach or discolor
paint and make plastic guards cloudy.