Southbend SB1014F User Manual

Page 41

For Machines Mfg. Since 7/09

EVS Toolroom Lathes

-35-

O P E R A T I O N

Use a caliper to measure both ends of the

workpiece.

— If the machined workpiece is thicker

at the tailstock end, move the tailstock
toward the operator

⁄

the distance of the

amount of taper (see Figure 61).

10.

Repeat Steps 7–9 until the desired accuracy

is achieved.

Move the tailstock toward

the operator half the

distance of the taper.

Looking down from above.

Figure 61. Adjust tailstock toward the operator.

— If the machined workpiece is thinner at

the tailstock end, move the tailstock away
from the operator

⁄

the distance of the

amount of taper (see Figure 62).

Move tailstock away from

the operator half the

distance of the taper.

Looking down from above.

Figure 62. Adjust tailstock away from the operator.

Note:

As long as this dead center remains in the

chuck, the point of the center will remain
true to the spindle center line. The point will
have to be refinished whenever the center is
removed and then returned to the chuck.

Install a center in the tailstock.

Attach a lathe dog to the piece of stock from

Step 3, then mount it between the centers,
as shown in Figure 60.

Figure 60. Example of round stock mounted between

the centers.

Turn 0.010" off the diameter of the stock.

Mount a test or dial indicator so that the

plunger is on the tailstock quill.

Note:

If necessary in the following step, refer to

"To Set Up the Tailstock to Cut a Shallow
Taper" on Page 34 for adjusting the
tailstock offset.