Sony MK7807V1 - Manual (Page 127)

Specifications
Inputs/outputs
SDI input:
SDI IN connector (BNC type) (1)
NTSC composite or 525/625 component
serial digital signal conforming to
SMPTE259M-A/C (ITU-R
BT.601/BT.656); 143, 270, Mb/s
(Selectable with on-board switch)
Input impedance:
75 Ω
Input return loss:
15 dB or more
Cable length:
200 m max. (When using a Belden
8281, Fujikura 5C2V or equivalent
coaxial cable)
SDI outputs:
SDI OUT connectors (BNC type) (2)
Serial digital video signal of the same
format
as that to the input connector
0.8 Vp-p
؎10%, 75 Ω
Output return loss:
15 dB or more (5 MHz to 270 MHz)
Analog audio signal inputs:
ANALOG IN AUDIO connectors (4)
XLR-3-31 (female), balanced (electronic
balance)
Input impedance:
600 Ω /20 k Ω (selectable with on board
switch)
Reference input level:
+4 dBm (-10 to +8 dBm continuously
variable)
Conversion characteristics
Quantization:
20 bit linear/48 kHz sampling
Headroom:
20 dB (at operation level)
Frequency response:
20 Hz to 20 kHz within +0.2/-0.3 dB (at
1 kHz standard)
Distortion:
Less than 0.05% (at 1 kHz, reference
level, 30 kHz low-pass)
Signal-to-noise ratio:
More than 106 dB
(Maximum output level, 30 kHz
low-pass)
Crosstalk:
Less than -90 dB (up to 15 kHz)
Input signal common-mode rejection
ratio
More than 80 dB (at 60 Hz)
Phase difference between channels
Within the same board: 0.1° or less (at 1
kHz)
Between the cascaded boards: 6° or
less (at 1 kHz)
Multiplex format:
Conforms to SMPTE 272M
Signal delay:
Component digital: approx. 0.78 µs
NTSC composite digital: approx. 1.47
µs
Analog audio:
Approx. 1.1 ms (at 525/625 component
serial digital)
Approx. 1.3 ms (at NTSC composite
serial digital)
EDH:
Conforms to SMPTE RP165
ISR Output information
Status message:
5 items
Status message:
8 items
General —
Power requirements:
+5 V DC: 610 mA, -5 V DC: 630 mA
(Supplied from the PFV-D/PFV-HD
Series Interface Unit)
Power consumption:
Approx. 6.2 W
Operating temperature:
5 to 40 °C (41 to 104 °F)
Storage temperature:
-20 to 60 °C (-4 to 140 °F)
Operating humidity:
10 to 90% (no condensation)
Dimensions
Board (H x W):
195 x 310 mm
(7 3/4 x 12 1/4 inches)
Connector panel (H x W):
195 x 25 mm
(7 3/4 x 1 inches)
Mass
Board:
Approx. 530 g (1 lb 3 oz)
Connector panel:
Approx. 180 g (6.3 oz)
V+A EDH
ISR
NTSC COMPOSITE/
525/625 COMPONENT SERIAL
DIGITAL VIDEO INPUT
ANALOG AUDIO
INPUT
NTSC COMPOSITE/
525/625 COMPONENT
SERIAL DIGITAL VIDEO
WITH EMBEDDED AUDIO
A/D
125
Interface Processor D Series
Inter
face Pr
ocessor D Series
*SGC_0117-0132 02.3.16 5:06 PM Page 125