Sun Microsystems Sun Fire X4200 M2 User Manual

Page 44

Sun Fire X4100 and Sun Fire X4200 Installation Guide • October 2006

▼

To Connect to the Server Using the Service
Processor’s IP Address

Note –

This procedure assumes that you have connected the server to your network

through an Ethernet cable.

1. If you have not already done so, determine the service processor’s IP address:

a. Power on main power to the platform by using a stylus to press the recessed

Power button on the front panel.

POST messages appear on your screen as the OS boots up.

b. Initialize the BIOS Setup utility by pressing the F2 key while the system is

performing the power-on self-test (POST).

c. When the main BIOS screen is displayed, select Advanced.

d. When the Advanced screen is displayed, select IPMI 2.0 Configuration.

When the IPMI 2.0 Configuration screen is displayed, select the LAN
Configuration menu item.

e. Select the IP Address menu item.

The service processor’s IP address is displayed using the following format:
Current IP address in BMC: xxx.xxx.xxx.xxx

2. Using a client system, establish a Secure Shell (SSH) connection to the service

processor’s IP address.

ssh -l root

3. Log in to the service processor as an Administrator, for example:

password: changeme

4. Start the ILOM console mode by entering the following:

start /SP/console

Only accounts with Administrator privileges are enabled to configure the SP serial
port.

5. If you have changed the SP Serial Port default settings, make sure you reset them

to the default settings.

6. Follow the Solaris 10 pre-installation on-screen prompts.

7. Use the information gathered in

“Installation Worksheet” on page 31

to help you

enter the system and network information as you are prompted.