Siemens 30ISDN - Manual (Page 42)

Programming the telephone settings
34
kap01.fm5 27.11.98 Profiset 30isdn engl.: A30853-X300-B107-1-7619
Connection code for parking/resuming a call
The connection code is a number under which a call can
be parked and later resumed (➔ page 18: ”Parking a call“).
The permitted values are 1 to 99 or “none“ (no input).
Date/time
The date and time are preset with zeros by default. The
correct date and time are set automatically by the switch-
ing centre the first time an outgoing call is set up. If your
network operator does not support this service, you can
program the date and time yourself. Your input is checked
for plausibility.
Call number for call forwarding unconditional
You can forward calls to another telephone in order to be
always reachable under your call number (➔ page 12:
”Call forwarding“).
The call number of the other telephone (including area
code) must have been programmed before activating call
forwarding.
a or d
Handset is on-hook, or a call is in progress.
S05 Start the programming procedure.
T
Enter the password if necessary.
T
Enter the connection code.
S Save the setting.
a
Handset is on-hook.
S13 Start the programming procedure.
T
Enter the password if necessary.
T
Enter first the date and then the time (e.g. “0709981022”
for September 7, 1998 7-09-98 10.22 a.m.).
Please note that you have to differentiate between a.m.
and p.m. in the following way:
“... 1030” stands for 10.30 a.m.
“... 2230” stands for 10.30 p.m.
S Save the setting.
a Handset is on-hook.
S02
Start the programming procedure.
T
Enter the password if necessary.