Sun Microsystems SUN STORAGETEK VSM GUI - Manual (Page 45)

312651601 • Rev A 27
CH APT ER
3
Installing PTFs for VSM GUI
This chapter describes how to install the corrective service PTFs for VSM GUI, which
you can download from the Sun StorageTek Customer Resource Center at:
http://www.support.storagetek.com.
Note – Before you install PTFs, you must install VSM GUI as described in “Installing
and Configuring the VSM GUI” on page 3.
For information on accessing the CRC, see “Customer Resource Center” on page xii.
Installing the PTFs
After you have downloaded the desired PTFs from the StorageTek CRC, install them
using the following procedure:
1. Ensure that you have customized the installation jobs as described in “Set Up the
SMP/E Environment and Install the Software” on page 13.
2. If necessary, modify member V1RCV .
Change the SMPPTFIN and SMPHOLD DDs to point to the downloaded data set names. If
there was no HOLDDATA downloaded, then remove the SMPHOLD DD and only receive
SYSMODS .
3. Run member V1RCV to RECEIVE the VSM GUI PTFs.
4. If necessary, modify member V2APPLY .
Before running the apply job, review the output from the receive job for HOLDDATA , and
follow the instructions given for each held PTF. When the requirements are met, bypass
the hold condition for that held PTF in the apply job with the BYPASS parameter. Do not
bypass HOLDERROR conditions.
5. Run member
V2APPLY
to
APPLY
the VSM GUI PTFs.