Smeg F166-5 - Manual (Page 11)

41
Instructions for the User
Cooking start time: as well as setting a cooking duration, the cooking
start time can also be set (with a maximum delay of 12 hours in relation to
the current time). To set the cooking start/end time, proceed as follows:
• Set the cooking duration as described in the previous point.
• Within 6/7 seconds of the last pressure on the or keys, press the
key again to set the cooking start time. The current time will appear
on the display with internal segments illuminated to show the end of
cooking time. Use the and keys to set the cooking start time.
• 6/7 seconds after the last key is pressed, the display will show the
current time and the cooking start and end times, which will be
represented by the illuminated inside segments. The display segments
will be constantly illuminated as long as the current time is not the
same as the cooking start time; as soon as the current time reaches
the set starting time, all the inside segments will start to flash,
indicating that the oven has started cooking.
• At the end of the cooking time the minute minder will switch the oven
heating elements off, the beeps will start to sound and the numbers on
the dial will flash.
• To reset the whole program set, keep the central key pressed for 1
or 2 seconds: if cooking has already started, the oven will have to be
switched off by hand.
• Here we can see a programming example: the
current time is 7:06 and cooking is programmed to
start at 8.00 and end at 9.00.
• At 8 o'clock the inside segments between 8 and 9
will start to flash, while the hours hand will remain
still.
Warning: for the oven to start cooking operations after the
programming procedures just described, the thermostat and
function selector knob must correctly set on the temperature and
function required.
6.1.4 "DEMO" Function
Models with analogue/digital programmer feature a "DEMO" function
which deactivates the heating elements while leaving the other functions
unchanged. To activate it, simply press the , and keys for 3/4
seconds. A confirmation beep will inform the user that the function is
active. To deactivate it, simply repeat the same procedure.