Safety agency compliance statements, Safety precautions – Sun Microsystems LSI22320-SR User Manual

Page 37

Appendix C Declaration of Conformity, Regulatory, and Safety Information

Safety Agency Compliance
Statements

Read this section before beginning any procedure. The
following text provides safety precautions to follow when
installing a Sun Microsystems product.

Safety Precautions

For your protection, observe the following safety
precautions when setting up your equipment:

■

Follow all cautions and instructions marked on the
equipment.

■

Ensure that the voltage and frequency of your power
source match the voltage and frequency inscribed on
the equipment’s electrical rating label.

■

Never push objects of any kind through openings in
the equipment. Dangerous voltages may be present.
Conductive foreign objects could produce a short
circuit that could cause fire, electric shock, or damage
to your equipment.

Symbols

The following symbols may appear in this book:

Caution –

There is a risk of personal injury

and equipment damage. Follow the
instructions.

Caution –

Hot surface. Avoid contact.

Surfaces are hot and may cause personal
injury if touched.

Caution –

Hazardous voltages are present.

To reduce the risk of electric shock and danger
to personal health, follow the instructions.

Depending on the type of power switch your device has,
one of the following symbols may be used:

On –

Applies AC power to the system.

Off –

Removes AC power from the system.

Standby –

The On/Standby switch is in the

standby position.

Modifications to Equipment

Do not make mechanical or electrical modifications to the
equipment. Sun Microsystems is not responsible for
regulatory compliance of a modified Sun product.

Placement of a Sun Product

Caution –

Do not block or cover the

openings of your Sun product. Never place a
Sun product near a radiator or heat register.
Failure to follow these guidelines can cause
overheating and affect the reliability of your
Sun product.

Noise Level

In compliance with the requirements defined in DIN 45635
Part 1000, the workplace-dependent noise level of this
product is less than 70 db(A).