Smeg SCP111BU2 User Manual
Smeg Kiln
This manual is related to the following products:
Table of contents
Document Outline
- Important safety instructions
- 2. INSTALLATION
- 3. OVEN GUIDE
- 4. AVAILABLE ACCESSORIES
- 5. USING THE OVEN
- 6. FUNCTIONS GUIDE
- 7. COOKING SUGGESTIONS AND TIPS
- 8. CLEANING AND MAINTENANCE OF THE OVEN
- 8.1 Cleaning stainless steel
- 8.2 Regular daily cleaning
- 8.3 Food stains or residues
- 8.4 Cleaning the inside of the oven
- 8.5 Cleaning the door glazing
- 8.6 Self cleaning: automatic oven cleaning
- 8.7 Before starting the automatic self cleaning cycle
- 8.8 Setting the self cleaning cycle
- 1 With the oven ON, use PT2 to select the self cleaning function.
- 2 To start the self cleaning cycle, press knob PT1 twice to set its duration.
- 3 Turn knob PT1 to the right or left to increase or decrease the cycle duration between a minimum of 1h 30m and a maximum of 3h 00m.
- 4 The message "CLEA" will appear on DSP1 to indicate that the oven is performing the cleaning cycle.
- 5 The time remaining until the end of the cleaning cycle will be shown on DSP1.
- 8.9 During and after the self cleaning cycle
- 8.10 Setting the self cleaning cycle with delayed start
- 1 Repeat steps 1, 2 and 3 described in “8.8 Setting the self cleaning cycle”.
- 2 After setting the duration, press PT1 once. The symbol and the current time will appear on the display.
- 3 Turning PT1 to the right increases the time, allowing the desired cooking start time to be set.
- 4 A few seconds after the desired duration is set, the symbols stay on, and the oven will start to wait for the starting time setting for the cleaning cycle.
- 9. SPECIAL MAINTENANCE
- WARNING
- WARNING