Smeg SCP111BU2 - Manual (Page 25)

Instructions for the User
27
9. SPECIAL MAINTENANCE
The oven may require special maintenance or replacement of parts subject to wear such as seals, bulbs,
etc. The following instructions describe how to do these minor maintenance operations.
WARNING
ELECTRICAL SHOCK HAZARD
Before any maintenance operation, disconnect the power supply of the
appliance.
9.1 Replacing the oven light
Remove upper oven
protection A and ring B as
well as the glass
cover C, unscrewing it
anticlockwise. Replace
light bulb D.
Reassemble ring B, cover
C and upper protection A.
CAUTION: The standard bulbs are halogen: do not touch them directly with your fingers. Use
insulation to protect your hand. Use only bulbs that are available at authorized service centers.
NOTE: use only oven bulbs (T 950°F - 500°C)
9.2 Removing the oven door
9.2.1 With moveable levers
With the door completely open, lift the levers A until
they touch hinges B, then grip the two sides of the door
with both hands close to the hinges. Raise the door to
an angle of about 45° and remove it. If the hinges don't
lock, repeat the operation, raising the levers and
keeping the door slightly raised. To remount the door,
fit the hinges B into their grooves, then lower the door
into place, making sure that it remains in the grooves
C, then lower the levers A.