JVC TM-1051DG - Manual (Page 8)

8
7Attaching the Power Cord Holder
• The provided Power Cord Holder prevents accidental disconnection of the AC power cord from the AC inlet.
• The Power Cord Holder consists of two parts; a case and a cover.
1. Attach the Power Cord Holder case to the AC inlet on the back of the monitor with 2
screws (provided).
Caution:
Use only the provided screws.
2. Attach the Power Cord Holder cover to the AC power cord.
Close the cover until it clicks.
3. Plug in the AC power cord to the AC inlet, and connect the Power Cord Holder cover to
the case.
Push until it clicks.
Caution:
• A different plug shape will result in the cover being
attached to a different position.
• Make sure the plug doesn't pull out after the cover is
attached.
NOTE:
• To disconnect the power cord, click the tab to open the
cover.
Preparation
EN03_LCT1993-001A-f.p65 06.1.5, 18:25 8