JVC TM-1051DG User Manual

Page 19

*1 The TRIG. (trigger) system switches each function by short-circuiting for approx. 1 second.
*2 When selecting the TRIG. (trigger) system, these functions cannot be controlled if no signal is input.
*3 Activates the settings of the items with “R-” or without “R-” in the “MARKER” menu.

☞ “MARKER” on page 12

*4 Tally lamp Control and External control (the 7th pin terminal) can be controlled by the MAKE (make contact) system even

when you select the “TRIG.” (trigger) system.

Operation

1. Short-circuit the 7th pin terminal (External control) to the 8th pin terminal (GND) so that the monitor can be controlled by the

external control.

2. When selecting the “MAKE” (make contact) system, operate each function by short-circuiting the corresponding pin

terminal to the 8th pin terminal (GND) or opening it.
When selecting the “TRIG.” (trigger) system, operate each function by Pulse control, that is short-circuiting the
corresponding pin terminal to the 8th pin terminal (GND) for about 1 second.

NOTES:
• When controlling INP. A/B/C/D, only one terminal must be short-circuited. (Other terminals must be opened.)
• When selecting the “TRIG.” (trigger) system, you can operate only one function at a time. Operate the functions one by one.

Display

INP. A

INP. B

INP. C

INP. D

CO. OFF

MARKER

ASPECT

MA. SEL

TALLY

TA. SEL

STATUS

L. METER

Functions to be controlled

Changes the input to INPUT A

Changes the input to INPUT B

Changes the input to INPUT C

Changes the input to INPUT D

Turns on/off COLOR OFF

Turns on/off MARKER

Changes ASPECT

Selects the MARKER settings

Controls the tally lamp

Selects the color of the tally lamp

Turns on/off the status display

Turns on/off AUDIO LEVEL METER

Opening

Invalid

Off

4:3

Selects the settings without “R-”

Off

Green

Off

Short-circuiting

Valid

On (Monochrome screen)

16:9

Selects the settings with “R-”

Red

Functions controlled by the MAKE/TRIGGER Terminal

EN04_LCT1993-001A-f.p65

06.1.5, 18:24