JVC BR-DV6000 - Manual (Page 88)

88
RS-232C INTERFACE – RS-232C commands – (continued)
B
B
B
C2
C4
C5
C8
C9
CA
CB
CC
CD
E2
FA
REVIEW KEY :
Review with the VCR
• It is required that [C0: Auto Edit] is
complete.
• Preroll time can be set with [E6:
Preroll Time Preset]. Without this
setting, the VCR menu switch set-
tings are followed.
• Upon the completion of review, the
VCR returns [01: Complete].
Full EE mode ON
Full EE mode OFF
SELECT EE ON :
Input signal check for the editing chan-
nel selected in [E5: Edit Preset].
SELECT EE OFF :
EE check release.
REC :
Recording. This command is transmit-
ted after transmitting REC/DUB RE-
QUEST.
REC PAUSE :
Record pause. This command is trans-
mitted after transmitting REC/DUB
REQUEST.
A.DUB :
Audio dubbing. This command is trans-
mitted during A.DUB PAUSE after
transmitting REC/DUB REQUEST.
A.DUB PAUSE :
Audio dubbing pause. This command
is transmitted during audio dubbing
after transmitting REC/DUB RE-
QUEST.
COUNTER RESET :
Counter reset E2 40.
REC/DUB REQUEST :
Recording request. (Use this com-
mand with a recording command).
● Return commands from the VCR
When the VCR received commands properly, it returns
the following commands.
01
03
05
0A
COMPLETION :
The VCR outputs this command when the
operation specified with Cue Up with Data,
Preroll, Auto Edit, etc. is complete.
CASSETTE OUT :
The VCR outputs this command when RS-
232C ejected the tape.
NOT TARGET :
The VCR outputs this command when the
operation specified with Cue Up with Data/
Preroll failed to be completed.
ACK :
This command is returned when a defined
command is received.
● Error commands
These are commands that are returned when trans-
mitted data cannot be received by the VCR properly.
Commands that release errors are also available.
02
41
56
0B
ERROR :
This command is returned when the
VCR receives an invalid command after
the second byte of a multi-byte
command. In this case, even if other
commands are sent continuously, no
command can be accepted. However,
status sense codes can be received.
To release errors, use the following
commands.
ERROR CLEAR :
Clears the last transmitted byte. Also
use this command to release errors.
CLEAR :
Cancels whole commands. Also use
this command to release errors.
NAK :
Returned when the VCR receives an
undefined command for the first byte or
a command specifying a function not
available for the VCR. Releasing the
error with the CLEAR command is not
necessary. Send the correct command.
Table Command Description
Command Description
Command Description
DV6000U_72-104_Eng.p65e 06/03/03, 11:42 PM 88