Connecting audio signals, Connection, Output signal – JVC BR-DV6000 User Manual
Page 30: Audio output switches and output channels, Analog signal, Headphone terminal, Audio output of vcr, Audio input of vcr
30
VIDEO
LINE
IN
OUT
MONITOR
OUT
DC12V
DV
IN/OUT
IN
OUT
OFF
AUDIO
REMOTE2
IN
B-Y
R-Y
SYNC IN
TIME CODE
IN
OUT
Y
COMPONENT
OUT
CH 1/3
CH 2/4
IN
OUT
MONITOR
OUT
REMOTE1
TIMER
REC
PLAY
SERIAL
REMOTE
SIGNAL
GND
Y/C
DV
DV
AUDIO
OUTPUT
switch
CH1/2
CH3/4
MIX
CH1
CH3
CH1/3
CH2
CH4
CH2/4
AUDIO OUT terminal
CH1/3
(L)
CH2/4
(R)
CONNECTION
– Connecting audio signals –
Audio output of VCR
Input
Audio input of VCR
Analog audio
Slot cover for optional board
(2 channels)
Monaural
Microphone
Stereo
Headphone
MONITOR OUT analog (monaural)
Monitor
Output
Ⅵ Output signal
When BR-DV6000 is in the STOP, REC or EDIT
mode, signals (EE sound), which have been
input, are output.
During the PLAYBACK mode (including the
playback of the pre-roll part during editing), the
playback sound is output.
However, in the edit mode with analog input,
signals cannot be output to the DV OUT termi-
nal properly.
● Analog signal
CH 1/3, CH 2/4 AUDIO terminal (RCA
ן2).
There are analog audio terminals for 2 chan-
nels.
For the DV format, tracks are available for 4
channels (in the 32kHz audio mode).
• In the 32kHz mode, from which one of the 4
channels sound is output can be selected with
the AUDIO OUTPUT switch on the front
panel. (Refer to the table on the right.)
● Headphone terminal
Sound can be checked in stereo using a
headphone. The volume can be adjusted with
the PHONES switch on the front panel.
• The channel to be output from this terminal
in the 32kHz audio mode can be selected
with the AUDIO OUTPUT switch. (Refer to
the table on the right.)
AUDIO OUTPUT switches and output
channels
In the following cases, the channels that receive
output from the AUDIO OUTPUT terminal vary
according to the setting of the AUDIO OUTPUT
switch. The table below shows the channels.
• During playback of tapes recorded in the 32kHz
audio mode.
• During audio dubbing.
• In the EE mode of DV input in the 32kHz audio
mode.
• In the 48kHz audio mode or during normal re-
cording, output goes to CH1 and CH2 regard-
less of the setting of the switch.
Analog audio (2 channels)
DV6000U_28-051_Eng.p65e
06/03/03, 11:39 PM
30