JVC BR-DV6000 - Manual (Page 43)

43
BR-DV6000
PROFESSIONAL
MENU RESET A.DUB
EJECT
COUNTER
AUDIO INPUT
SELECT MONITOR OUTPUT REMOTE
LOCAL
CTL L
MIX
R
CH-1/2
MIX
CH-3/4
DV
LINE
Y/C
(CPN)
TC
UB
REW STOP FF
REC
OPERATE
PLAY PAUSE DISP
SET SEARCH+
BLANK CUE UP HOLD
PHONES REC LEVEL
CH-1/3 CH-2/4
MIC
SEARCH–
Mini
Memo
If recording is performed
right after the RECORD-
ING PAUSE mode is exited,
index signals are not re-
corded.
Memo
● The tape protection func-
tion enables BR-DV6000
automatically to go into
the STOP mode when
there is a long recording
pause. The time to go into
the STOP mode can be
set with LONG PAUSE
TIME in the SYSTEM
(1/2) Menu screen.
● When a home-use DV
VCR is used to play
tapes recorded with
BR-DV6000, the sound
level may be reduced.
Recording index signals
Ⅵ Press the REC button to record index signals during
recording
❈ It is not possible to record only index signals after the recording.
Allow at least an interval of 1 minute between recordings of in-
dex.
❈ Index signals cannot be recorded with the REC button of the
remote controller. Use the record button of BR-DV6000.
If INDEX WRITE is set to ON in the SYSTEM (2/2) Menu screen, an index signal is recorded at the
recording starting position of the tape. In the PLAYBACK mode, the position where the index signal
is recorded can be searched. (Index search)
1.
Load the cassette tape.
• Before loading the cassette tape, please ensure that the rear
slide of the cassette tape is pushed to REC.
¥ The unit is turned on.
2.
Adjust the audio recording level.
• Adjust the REC LEVEL volume. Adjust it such a way that, with
the maximum volume, the audio level meter does not display
OVER.
❈ During DV input, the REC LEVEL volume cannot be adjusted.
3.
Start recording.
• Press the PLAY button while holding down the REC button.
4.
Pause recording.
• Press the PAUSE button.
5.
Resume recording.
• Press the PLAY button.
6.
Stop recording.
• Press the STOP button.
3.
REC button
3. 5
PLAY button
4.
PAUSE button
2.
REC LEVEL volume
6.
STOP button
RECORDING
– Recording procedure –
DV6000U_28-051_Eng.p65e 06/03/03, 11:39 PM 43