JVC BR-DV6000 User Manual

Page 87

VISS FORWARD :
Index search in the forward direction.
For the index search position, enter a
3-digit number (001-099) following the
command.
When a 3-digit number has been en-
tered, index search starts.
If ENTER (40H) is transmitted before
all three digits are entered, the remain-
ing digit(s) are considered as “0” (30H),
and index search starts.
VISS REV :
Index search in the reverse direction.
For the index search position, enter a
3-digit number (001-099) following the
command.
When a 3-digit number has been en-
tered, index search starts.
If ENTER (40H) is transmitted before
all three digits are entered, the remain-
ing digit(s) are considered as “0” (30H),
and index search starts.
CUE UP WITH DATA :
Use this command to cue up a speci-
fied point on the tape. When the tape
is cued, COMPLETION is returned
and the Pause mode becomes effec-
tive.
To specify a cue point, transmit the
time data (hour: minute: second: frame,
a total of 8 bytes with 2 bytes for each)
following this command. By transmit-
ting ENTER (40H) with the time data,
transmission of lower data becomes
unnecessary. In such a case, “0” is
transmitted. If the specified point can-
not be found, NOT TARGET (05H) is
returned.
CUE UP AND PLAY WITH DATA:
Use this command to cue up a speci-
fied point on the tape. When the tape
is cued, COMPLETION is returned
and the Play mode becomes effective.
To specify a cue point, transmit the
time data (hour: minute: second: frame,
a total of 8 bytes with 2 bytes for each)
following this command. By transmit-
ting ENTER (40H) with the time data,
transmission of lower data becomes
unnecessary. In such a case, “0” is
transmitted. If the specified point can-
not be found, NOT TARGET (05H) is
returned.

F-SHUTTLE :
Shuttle play. The search speed is
specified by sending the speed code
data after this command (see the ta-
ble below).

3Bh and 3Ch are effective only for B5.
R-SHUTTLE :
Shuttle reverse play. The search speed
is specified by sending the speed code
data after this command (see the ta-
ble above).
AUTO EDIT KEY :
Audio editing with the VCR.
• It is required that the editing chan-

nel is selected in [E5: Edit Preset].

• This audio editing command must be

used with [FA: Rec Request].

• Preroll time can be set with [E6:

Preroll Time Preset]. Without this
setting, the VCR menu switch set-
tings are followed.

• Upon the completion of auto editing,

the VCR returns [01: Complete].

PREVIEW KEY :
Preview with the VCR
• It is required that the editing chan-

nel is selected in [E5: Edit Preset].

• This preview command must be

used with [FA: Rec Request].

• Preroll time can be set with [E6:

Preroll Time Preset]. Without this
setting, the VCR menu switch set-
tings are followed.

• Upon the completion of preview, the

VCR returns [01: Complete].

Speed code

Search speed

30h

STILL

31h

0.1

32h

0.2

33h

0.33

34h

0.5

35h

36h

37h

38h

39h

3Bh

X0.90

3Ch

X1.07

Speed code table

(Supported speed only)

Table

Command

Description

Table

Command

Description

DV6000U_72-104_Eng.p65e

06/03/03, 11:42 PM