JVC KD-NX5000- - Manual (Page 84)

ENGLISH
84
Registering using Open
1
Mode
]Open
2
Enter a PIN (Personal
Identification Number)
* code to
the unit.
• Inputting characters ☞ [105]
• You can enter any number you like (1-
digit to 16-digit number).
* Some devices have their own PIN code. Enter the
specified PIN code to the unit.
3
Select Connect.
4
Operate the target Bluetooth
device.
Enter the same PIN code (as entered in the
above step) on the device to be connected.
Now connection is established and you can use
the device through the unit.
Searching for available devices
1
Mode
]Search
The unit searches for available devices and
displays the list of them. (If no available
device is detected, Device Unfound
appears.)
2
Select a device you want to
connect.
3
Enter the specific PIN code of
the device to the unit.
• Inputting characters ☞ [105]
• Refer to the instructions supplied with the
device to check the PIN code.
4
Use the Bluetooth device to
connect.
Now connection is established and you can
use the device through the unit.
Searching...
Connecting...
The device remains registered even after
you disconnect the device. Use Connect
(or activate Auto Connect) to connect the
same device from next time. (☞ [89])
Open...
0000
BS Connect
To register another device after you have
registered a device, make sure New Device
is selected. (☞ [85])
Connecting a special device
1
Mode
]Special Device
The unit displays the list of the preset
devices.
2
Select a device you want to
connect.
3
Use Open (or Search) to
connect.
KDNX5000_J.indb 84 KDNX5000_J.indb 84 23/1/07 7:00:52 pm 23/1/07 7:00:52 pm